Where to Display Your Dead by Daylight Notebook and Print Materials

Quick answer

Display your Dead by Daylight notebook and prints where they get seen but not punished: out of direct sunlight, away from heat and moisture, and high enough that drinks and pets can't reach them. Rotate pieces seasonally, dust with a dry microfiber cloth, and keep anything rare or out-of-print in a sleeve or frame rather than loose on a shelf.

You finally have the notebook and prints you wanted, and now the hard part: where do they actually go? A shelf that looks great in a photo can wreck paper goods in a few months if it sits under a window or next to a radiator.

This guide walks through a practical display setup, from picking the wall to rotating pieces so the arrangement stays interesting. It also covers the storage side, because the best display plan includes a safe place for the pieces you are not showing right now.

Start with light, heat, and moisture

Paper is the most light-sensitive material in most gaming collections. Direct sun fades inks and yellows pages faster than almost anything else you can control, so the first decision is placement, not frames or shelves. An interior wall that never receives direct sun is the safest home for a Dead by Daylight print material display.

Heat and moisture matter just as much. Avoid spots above radiators, beside kitchen steam, or against damp exterior walls. If a wall feels cold or clammy to the touch, paper stored or hung there will eventually ripple or spot. A simple hygrometer can confirm a room stays in a moderate range before you commit to a layout.

• Check the wall at midday and again in late afternoon to see where sun actually lands.
• Keep at least a few inches of air gap behind frames so moisture does not trap against the wall.

Choose a display height that protects the piece

Eye level is the default for art, but for a working desk setup the better rule is out of the spill zone. Anything below roughly waist height on a desk or open shelf is in range of mugs, cans, and clumsy elbows. Raising a notebook or print even a foot reduces the odds of a permanent stain.

If you want pieces within arm's reach, put the replaceable items low and the sentimental ones high. That way the display still feels lived-in, but the items you would hate to lose are not the ones absorbing daily risk.

• Use a small riser or floating shelf to lift paper goods above drink height.
• Keep the lowest shelf for items that can handle a bump, like a beanie or a tee folded flat.

Pick a frame or sleeve that matches how you use the piece

Framing is for pieces you want to look at every day and never touch. A frame with UV-filtering glazing and a mat keeps the print off the glass, which prevents sticking and condensation marks over time. It also makes dusting trivial because you are cleaning glass, not paper.

Sleeves and portfolios are for pieces you flip through or rotate. An archival sleeve with a rigid backing board lets you store prints flat and pull one out without handling the surface directly. Notebooks are their own case: if you write in it, keep it out of the frame and treat the cover as a working surface.

• Handle prints by the edges or with clean cotton gloves to avoid oils transferring to the paper.
• Do not tape or glue a print to a backing board; use photo corners or a sleeve instead.

Build the shelf so it reads as a collection, not clutter

A good Dead by Daylight shelf display idea is really a grouping decision. Anchor the arrangement with one larger piece, then add two or three smaller objects at different heights. Odd numbers and varied heights read as intentional; rows of identical items at the same level read as storage.

Leave negative space. Crowding paper goods against each other makes them harder to dust and easier to knock over. A little breathing room also means you can swap a piece in or out without rebuilding the whole shelf.

• Group by theme or color rather than by product type for a cleaner look.
• Snap a photo of the arrangement before you change it so you can rebuild it later.

Rotate pieces and store the rest properly

Rotation is the single best way to enjoy more of your collection without exposing any one piece to years of light. Change the display every few months, and return the outgoing piece to its sleeve or flat storage box. This keeps the wall fresh and spreads wear evenly across the collection.

Store flat, not rolled, unless the piece has been rolled for a long time already. Stack prints with acid-free tissue between them and keep the box in a cool, dry, dark place. Notebooks should stand upright or lie flat, never lean at an angle for months, which warps covers and loosens spines.

• Label storage sleeves so you can find a piece without digging through the whole box.
• Never store paper goods in a basement or attic where temperature swings are extreme.

Your display setup, step by step

1. 1. Audit the wall before you hang anything: Watch the intended wall at three points in the day to confirm no direct sun hits it. Check for radiators, vents, and damp exterior walls nearby. If sun reaches the wall for more than an hour, choose a different wall or plan for UV-filtering glazing.
2. 2. Set your height zones: Mark a spill zone below roughly waist height and a safe zone above it. Put notebooks and prints in the safe zone, and reserve the low shelf for durable items. If a piece would be ruined by one knocked-over drink, it does not belong in the spill zone.
3. 3. Match each piece to a frame or sleeve: Frame pieces you want on permanent view with a mat and UV-filtering glazing. Sleeve pieces you rotate or handle, and keep working notebooks out of frames. If you touch it often, sleeve it; if you only look at it, frame it.
4. 4. Arrange the shelf in odd-numbered groups: Anchor with one large piece, then add two or three smaller objects at varied heights. Leave visible gaps between items so dusting is easy. If the shelf looks like a storage row, remove one item and raise another.
5. 5. Photograph the arrangement: Take a quick photo of the finished shelf from straight on. This becomes your reference for rebuilding after cleaning, moving, or rotating pieces. A photo saves you from redoing the layout from scratch every season.
6. 6. Rotate every three to six months: Swap out one or two pieces per rotation and return the outgoing items to their sleeves or flat storage. Dust the shelf while it is empty. Rotation spreads light exposure across the collection instead of concentrating it on one piece.
7. 7. Store the off-display pieces flat and dark: Use acid-free tissue between stacked prints and keep the box in a cool, dry, dark place. Stand notebooks upright or lay them flat, never leaning at an angle. If storage is humid or temperature swings hard, move it before the paper shows damage.

Products that fit this display plan

• Dead By Daylight Soundtrack (Purple alternate cover): This is a leftover copy of the long out-of-print purple variant cover of the Volume 1 soundtrack, ships from Canada, and requires special packaging so it ships separately from other purchases. Because it is out of print and ships separately, treat it as a display piece rather than a daily-use item, and store the record upright away from sun and heat so the cover and vinyl stay flat.
• Dead by Daylight – Cold Fog Fisherman Beanie: It has a chunky rib knit with a short, snug cuff and an embroidered Dead by Daylight logo patch across the front. The embroidered patch and rib knit make it sturdy enough for a low shelf or hook, but keep it out of direct sun so the knit does not fade and the patch does not loosen.

A display that protects your Dead by Daylight notebook and prints comes down to three habits: keep them out of direct sun and damp air, lift them above the spill zone, and rotate what is on view. Do that, and the shelf stays a showcase instead of a slow loss.